Rush Multibeam 2 Uživatelský manuál stáhnout pdf (Strana 16)

16 RUSH Multibeam 2 User Manual

2. Use the UP and DOWN buttons to select a new address (1 to 512).

3. Once the address has been selected, press ENTER to set it (or to return

to the previous menu level without making a change, press MENU).

Master/slave mode

Fixtures on a data link can run synchronized shows in stand-alone operation if

you set the first fixture on the data link to Master mode and the other fixtures to

Slave mode. In Master/Slave mode, the first fixture runs a preprogrammed or

sound-activated stand-alone show, and the other fixtures run a show that is

synchronized with the first fixture.

In Master/Slave mode, all fixtures must be in stand-alone operation: they must

not be receiving a DMX signal and BLACKOUT must be set to No.

Fixtures’ MASTER and SLAVE LEDs light to indicate the mode they are set to.

If the master fixture is set to Music trig, its SOUND LED flashes in sync with

the music beat.

Important: set only the first fixture on the data link to MASTER mode.

To adjust a fixture’s MASTER/SLAVE settings:

1. Select SLAVE MODE

and press the ENTER button.

2. Use the UP and DOWN buttons to select from:

• Master – fixture runs a stand-alone show (sound-activated or

preprogrammed) and sends synchronizing information to connected

slave fixtures, or

• Slave 1 – fixture receives synchronizing information and runs the

same show as the master fixture, or

• Slave 2 – fixture receives synchronizing information and runs a show

that is in sync with the master fixture’s show but is not identical to it.

3. Once the mode has been selected, press the ENTER button to set it. Or to

return to the higher level of the menu structure without making a change,

press the MENU button again.

Show settings

Show settings determine the behavior of the fixture when it is disconnected

from DMX and configure the fixture’s stand-alone behavior.

Blackout mode

The fixture can be set so that, if it does not receive a DMX signal, it either

blacks out or runs its stand-alone show. This is set to No (fixture runs stand-

alone show when it does not receive DMX) by default.

To adjust the blackout settings:

1. Select BLACKOUT

and press the ENTER button to confirm.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Žádné komentáře

Rush Multibeam 2 Uživatelský manuál Strana 16